• Short brass lamp socket with no switch. I use Leviton brand socket.
• 8 feet of lamp cord.
• Lamp plug. Make sure you buy one small enough to pass through the wick tube.
• Touch Control switch. I like the one that just plugs into the outlet.
• 1/2" felt stick-on furniture saver pads.

1~ Remove the flame spreader and set it aside.
2~ Wire the socket to one end of the wire and attach the plug to the other end.
3~ Stick 3 furniture savers pads to the bottom of the lamp. This should lift the lamp high enough for the wire to pass under the lamp when you install it. If it isn't high enough add another pad to each of the ones you have already applied, making to bottom 2 pads high.
4~ Thread the plug through the wick tube from the top. As you draw the wire through you will find that the socket just fits into the tube. Wedge it in so that it won't move.
5~ Plug the lamp into the touch control and the touch control into the wall outlet.
6~ Replace your chimney and shade.
I like to place the flame spreader in a plastic bag and attach it to the cord so I don't loose it.